Advertisement
Available languages
Available languages
important
Notes
to the
installer
1.
Read all instructions
contained
in these installation
instructions before installing appliance.
2.
Remove all packing material
from appliance
before
connecting the electrical supply.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
important
Note
to the
Consumer
Keep these instructions for future reference.
IMPORTANT
SAFETY
INSTRUCTION
• Be sure your appliance
is installed
and plugged
into
a 120 Volt grounded
outlet.
• This appliance
must
be electrically
grounded
in
accordance
with
the National
Electrical
Code ANSI/
NFPA No. 70--latest
edition
in the United
States,
or CSA C22.1,
Part
I in Canada,
and local
code
requirements.
Tools You Will
Need
Phillips@ Screwdriver
Pencil
Ruler or Tape Measure and Straight-edge
Hand Saw or Saber Saw
Spirit Level
Warm
& Serve
Drawer
Installation
1.Locate the 2 anti-tip brackets supplied as shown on fig. 1.
......
_
% 2 5 %6"
.- ;_
.....
(64,3cm)
.......
.%
I
...-"
]-'_-_
I ...........24" (61 cm)Max.
.-ir_
"-_, .-',"_23
%" (60 cm) Min.
(32,2 cm) .............
\A_
Figure 1
e_.-"
Use screws
supplied to attach
........
drawer to front of
-_°_'
cabinet.
Figure 2
Electrical
connection
IMPORTANT Please read carefully.
For personal
safety, this appliance
must be properly
grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle to minimize the
possibility of electric shock hazard from the appliance.
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is properly
grounded.
Where a standard 2-prong wall receptacle is installed, it is
the personal responsibility and obligation of the consumer
to have it replaced by a properly grounded 3-prong wall
receptacle.
Do not, under any circumstances,
cut or remove the
third (ground)
prong from the power cord.
Disconnect electrical supply cord from wall
receptacle before servicing cooktop.
Preferred Method
2.Slide drawer
into cutout
opening
until front frame of
drawer is flush against cabinet. Be careful not to pinch
electrical cord.
3.Remove the drawer
as instructed
in the Use & Care
Guide and secure drawer housing to cabinet using the
3 nickel-plated
screws supplied (see Figure 2). Do not
overtighten
screws.
4.The 60" (1 52,4 cm) appliance
power cord can now be
connected into the 120 Volt outlet.
5. Proceed with mounting built-in oven above the drawer (if
applicable). Follow installation
instructions provided with
built-in oven. Make sure to use anti-tip brackets supplied
with the built-in oven.
Grounding type
wall receptacle
Do not, under any
circumstances,
cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug.
Advertisement
