Installation - Electrolux E30EW8CGPS6 Installation Instructions Manual

6. Cabinet Installation
Heavy Weight Hazard
• Use 2 or more people to move and install wammoven.
• Failure to folmow this instructions can resumt in injury
or damage to the unit.
The wall oven can tip when the door
is opened. The mounting brackets supplied with
the wall oven must be attached to the cabinet and
the appliance to prevent tipping of the wall oven
and injury to persons.
Mounting Bracket installation instructions
1.Find the 2 mounting brackets and screws included in
the literature package.
2.Install the mounting brackets in the cabinet as shown on
figure 8. Note: To prevent damage to cabinet, it is
recommended to drill I/16" (0.16 cm) dia. pilot holes
before installing the mounting brackets.
F
_ 5ingle Oven see Fig. 1 _ Double Oven see Fig. 2
Mounting a
Brackets H
Single Oven see Fig. 1
Single Oven: Double Oven see Fig. 2
23 I/4" (59.1 cm)
a Double Oven:
gg 46Y2" (118.1 cm)
i....l_ ....,.............
Figure 8
3. Insert the unit into the cabinet opening. Slide unit inward
leaving 3" (7.6 cm) clearance between the oven and
front of cabinet (Figure 9). Pull the armored cable
through the hole in the floor and toward the junction box
while moving the appliance inward.
4. Install now the bottom trim using the screws supplied
withthe unit (Figure 10).
5.Push the unit in and against the cabinet, then the oven
side bracket will clip in the one you just install on the side
of the cabinet opening.
To pull out the oven for servicing insert the tool supplied
with the appliance both side at the same time in the hole
located on the side frame and visible when the door is
opened. After inserting the tool pull the oven towards
you (see figure 11).
6. For typical under counter installation of an electric built-in
oven see Figures 12 and 13.
f
Figure 9
Oven
_racke_._
-_" 3" (7.6 cm)
clearance between unit
and front of cabinet
I
Figure 10
Mounting
bracket installed
Cabinet
Right Side
_1_ Tool
..... supplied
2
iii_i!i_ili!!i/
Mounting
bracket released
Oven removed from
the cabinet
Hole where to insert
the tool
Figure 11