Advertisement
IP Address
Subnet Mask
Gateway
H (Hops)
IF (Interface)
Select a route from the list and click on the Edit Route button to
change the configuration of an existing route.
Select a route from the list and click on the Delete Route button
to remove a route.
Once the routes have been set up as required, click on Apply.
Enter here the IP address of the subnet/range
you want to route to (enter a zero in the last
segment of the IP address for each range).
Enter here the Subnet Mask of the above IP
Address, either for the Token Ring side or the
Ethernet network.
Enter here the IP address of the router for the
side of the network the above IP addresses are
on (for example, if the IP addresses are on the
Ethernet network, enter the address assigned to
the first IP Address field previously - for the Token
Ring side use the address assigned to the Local
IP Address field).
Enter here the number of hops across networks
or subnets that are necessary to route the packets
to the required IP Address.
This remains at the default setting of 1.
Advertisement
