Advertisement
Passwords
It is strongly recommended that Passwords are set for access
to all router property pages in PeripheralVision
sensitive nature of the information that can be configured.
If required, access to set/change the information on the router
property page can be restricted using the Change Password
button. Click on it to bring up the following window:
Enter the Password into the box, type in the confirmation and
click on OK.
Access to change the configuration will now be restricted to
those who have the Password.
Routing Table Page
7 It is now necessary to tell the router where to route the IP packets.
This is done by creating a Routing Table. Use the arrows to
scroll the pages and select the Routing Table page. Make
sure that the whole IP range is passed over to the other network.
Any packets that are not in this range will be passed onto the
Default Gateway Address . An example of this setup is shown
following.
To configure each route, click on the Add Route button and
enter the information as described:
®
because of the
Advertisement
