Auto Register - IC Realtime Mobile Network Video Recorder User Manual

Saturation
Day/Night Mode
BLC
Gain Mode
Gain Adjust
WB
Mirror
Flip
Watermark

6.4.4.2 Auto register

The auto register interface is shown as in Figure 6-61.
You can set the server IP and port if you want to use the auto register function. After the device
registered to the server, you can access the device after the client-end connected to the server.
It is to adjust monitor window saturation. The value ranges from
0 to 100. The default value is 50.
The larger the number, the strong the color is. This value has no
effect on the general brightness of the whole video. The video
color may become too strong if the value is too high. For the
grey part of the video, the distortion may occur if the white
balance is not accurate. Please note the video may not be
attractive if the value is too low. The recommended value ranges
from 40 to 60.
It is to set device color and the B/W mode switch. The default
setup is on.
Color: Device outputs the color video.
Auto: Device auto select to output the color or the B/W
video according to the device feature (The general bright of
the video or there is IR light or not.)
B/W: The device outputs the black and white video.
This function can make the target clearer. It can make the
details of the dark section become clear when the background is
too bright.
This function is disabled by default.
It is to set video noise. Check Auto, system automatically sets
video gain. Check Manual, you can set gain threshold,
brightness and etc.
Gain threshold: Here is for you to set gain value. The different
series product has different default values. The lower the value
is, the lower the noise is. But the video brightness may become
too dark under the low illumination. If the value is high, it can
enhance the video brightness under the low illumination, but the
video noise may become high.
Enable white balance is to allow the camera to restore the white
object. It can correct the color temperature between the indoor
and outdoor environment.
It is to switch video left and right limit.
This function is disabled by default.
It is to switch video up and bottom limit.
This function is disabled by default.
Please note the video resolution shall be 720P or lower when it
is to flip 90° .
Enable this function to check the video has been tampered with
or not.
132