Belkin N300 User Manual page 26

Using YOUR ROUTER
Click on "Channel and SSID" in the left column
under the "Wireless" heading .
Configure the following parameters .
SSID: Set the wireless network name . the SSID can contain up to
32 alphanumeric characters . the default SSID is "belkin .###" .
Broadcast SSID: If checked, the Router broadcasts its SSID in
the wireless network, so that wireless clients can scan the SSID
and access the wireless network under the SSID . the check box
is selected by default . If the check box is cleared, only devices
that know the correct SSID can connect to the Router .
For the remaining settings, use the defaults .
the default channel is Auto .
It is unnecessary to change the wireless channel unless
you notice interference problems with another nearby
wireless Router or access point . Select a channel that is
not being used by any other nearby wireless networks .
the default mode is 802 . 1 1b/g/n .
If you do not know which mode to use, select 802 . 1 1b/g/n .
the default bandwidth is 20/40mhz .
the default protected mode is off .
In most situations, best performance is achieved with
Protected mode off . If you are operating in an environment
with hEAVY 802 . 1 1b traffic or interference, best performance
may be achieved with Protected mode on .
the default 802 . 1 1e/Wmm QoS mode is on .
QoS prioritizes important data on your network such as
multimedia content and voice-over-IP (VoIP) so it will not be
interfered by other data being sent over the network .
Click "Apply Changes" .
26