Belkin N300 User Manual page 22

Using YOUR ROUTER
Configure the parameters below .
user name and Password: Enter the user name and
password provided by the ISP . the user name and
password are used to log in to the ISP server .
Retype Password: Enter the password again .
Service name: If several PPPoE servers are
available, specify which server to use .
IP assigned by ISP: You can select either to an IP address assigned
by your ISP, or to manually set an IP address in the "IP Address" field .
mtu: the maximum transmission unit . We strongly
recommend you to use the default setting unless
your ISP gives you a specific mtu setting .
If you select the "Disconnect after xxx minutes of no
activity" check box and specify a time interval, the system
interrupts the Internet connection when there is no
Internet access behavior within the specified time .
Click "Apply Changes" .
If after a few minutes your Internet Status says
"Connected", you're done! You can surf the Internet .
PPTP/l2TP Connection
Some ISPs require a connection using the PPtP or L2tP protocol .
Enter the account and password provided by your ISP .
the following takes PPtP connection as an example .
setup steps:
Click "Connection type" in the left column
under the "Internet WAn" heading .
Select "PPtP" in the "Connection type" page that appears .
22