Belkin N300 User Manual page 21

Using YOUR ROUTER
Click "Click here to enter your DnS Settings"
to configure DnS information .
Clear the "Automatic from ISP" check box .
In the "DnS Address" and "Secondary DnS Address" fields, enter
the IP addresses of the primary DnS server and the secondary
server (if available) . At least enter one DnS server IP address .
Click "Apply Changes" .
If after a few minutes your Internet Status says
"Connected", you're done! You can surf the Internet .
PPPoE Connection
most DSL providers use PPPoE (Point-to-Point Protocol over Ethernet)
as the connection type . If you use a DSL modem to connect to the
Internet, your ISP may use PPPoE to log you into the service .
setup steps:
Click "Connection type" in the left column
under the "Internet WAn" heading .
Select "PPPoE" in the "Connection type" page that appears .
21