St6105J Sensorsoft Thermometer Specifications - Sensorsoft ST6105J User Manual

Hide thumbs Also See for ST6105J:
Table of Contents

Advertisement

Sensorsoft Thermometer User Manual

ST6105J Sensorsoft Thermometer Specifications

Measurement Range: -40 º C to +60 º C (-40 º F to +140 º F)
Resolution or precision: 0.1 º C (0.18 º F)
0.5 º C (0.9 º F)
and
Accuracy: +/- 0.5 º C (+/- 0.9 º F) over 0 º C to +60 º C (32 º to 140 º F) and
+/- 1 º C (1.8 º F) over remainder of temperature range
Calibration: Calibrated at the factory. Re-calibration in the field is not possible, but sensor can
be replaced. See Sensor type below for replacement part number.
Maximum measurement rate: one reading every second
Housing Dimensions: 8 cm (3.1") x 4 cm (1.6") x 2 cm (0.8")
Housing Material: injection molded ABS thermoplastic
Housing Colour: light gray
Sensor type: semiconductor, internal (Dallas Semiconductor DS18S20)
Communications connector: 8 position modular jack, (accepts 8 position plug RJ45)
Power source: Port-powered (RTS and DTR, both asserted) or via External DC power connector
Power supply current drain: < 10 mA
External DC power connector: 2.1 mm power jack, automatic polarity correction and over-
voltage protection.
External power supply voltage: 6.0 - 12.0 VDC
Communications Interface: RS232C using TX,RX,RTS,DTR and GND. One device per serial
port.
Maximum communications cable length: 305 m (1000 ft.) using recommended cable type. Low
capacitance shielded cable or UTP is recommended.
Communications Protocol: Sensorsoft Device Protocol, Version 2.0
Error control: 16 bit CRC (cyclic redundancy checking) for detection of communication errors
between the device and host computer.
8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ST6105J and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

St6105cSt6154j

Table of Contents