Regular Maintenance - Vax Performance Cyclonic V-008SC Instruction Manual

Vax V-008SC User Guide.qxd
Pull out and wipe with a damp cloth to clean (Fig.5/12).
Fig.5/12
Dry and return the air director to the dirt container. Rotate
1/4 turn clockwise to lock in place (Fig.5/13).
Fig.5/13
Replace dirt container:
Return dirt container to cleaner. Align slot on bottom of
dirt container with tab on cleaner. Push to snap into place
(Fig.5/14).
Fig.5/14
6/3/07 14:14 Page 9

Regular Maintenance

Each time the dirt container is emptied, the filter
should be cleaned. Tap the filter firmly against the
inside of a dustbin until the dirt stops falling from the
filter.
The filter will be discoloured after use, but this will
not affect the filter's performance.
Do not brush the filter.
The cleaning instructions may vary depending on the
dirt conditions. In some cases, more or less cleaning
of the filter may be required.
6. Belt or Brushbar: Removal
and Replacement
Tool required: Phillips screwdriver
!
brushbar.
To remove belt:
Lay cleaner flat and flip cleaner to expose nozzle base.
Base should lay flat and face up. The remove nozzle guard,
use Phillips screwdriver to remove the three (3) screws.
Arrows show location of screws (Fig.6/1).
Fig.6/1
Pull and lift nozzle guard off (Fig.6/2).
Vax Careline
WARNING: To reduce the risk of injury from moving
parts, unplug cleaner before changing belt or
belt or brushbar replacement
0870 606 1248
9