Hardware Installation - JustCom 201ASU User Manual

JC-201ASU/401ASU

Hardware Installation

Connecting the Auto Switch
1.Connect the A-type connector cable of your USB device to the A-type
USB port on the Auto Switch.
2.Install the drivers for your USB (1.1/2.0) device. Refer to the device's
user manual for additional information on installing the driver.
Connecting the Computers
1.Connect the USB cable's A-type connector to an available USB port
on your USB computer.
2.Connect the USB cable's B-type connector to any port on the Auto
Switch.
3. Repeat steps 1 & 2 for each additional USB computer (up to four)
you wish to connect.
Now JustCom's USB 2.0 Auto Switch is ready for use.
-7-