How To Reset Parameters To Their Default Values (Reset) - SEH ThinPrint TPG-25 User Manual

What do you want
to do?
TPG User Manual
6.3 How to Reset Parameters to their Default Values
(Reset)
It is possible to reset the parameters of the TPG to their default
values (factory settings). All previously configured parameter values
will be deleted in this process. Installed certificates will not be
deleted.
If you reset the parameters, the IP address of the TPG may change
and the connection to the TPG Control Center may be terminated.
You must reset the parameters, for example, if you have changed the
location of the TPG and if you want to use the TPG in a different
network. Before this change of location, you should reset the
parameters to their default settings to install the TPG in a different
network.
Remove an attached USB flash drive before resetting the
parameters. If a parameters file is saved on the USB flash drive, the
TPG will - after the reset - automatically use the parameter values
saved on the USB flash drive (see:
By means of the status/reset button of the device you can reset the
parameters without entering the password.
'Resetting the parameters via the TPG Control Center'
'Resetting Parameters via the InterCon-NetTool'
'Resetting the parameters via the status/reset button'
Resetting the parameters via the TPG Control Center
Proceed as follows:
1. Start the TPG Control Center.
2. Select MAINTENANCE - Default settings.
Maintenance
71).
75
74
75
74