Table of Contents
Advertisement
Auto Sequencing Setting
Auto Sequencing is used either in the main screen when Auto Sequencing has been enabled or when a Spot-Monitor Out signal is
used to display video on a spot monitor. Auto Sequencing conveniently displays video channels and at specified intervals, sequences
through each selected channel.
Enable Sequencing
Enable All Cameras
Select interval between
switching cameras
Channel Selection
Custom Mode
Skip 0 FPS Channel
Create Custom Auto Sequence
1.
Open General Setup and click the Sequence Setting button.
2.
Click individual cameras in the left pane or click the Select All button to include all cameras in the sequence.
3.
Select an interval time (in seconds) to display each screen in the sequence.
4.
Select Screen Division options for appropriate cameras.
5.
Click the OK button.
52
Click each channel to include in Auto Sequencing.
Enable to create non-standard screen divisions
Sequence skips cameras with no video signal.
Screen Division Options
Advertisement
Table of Contents
