Yamaha YZF-R6P Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
3
1. Oil level symbol " "
2. Oil level/coolant temperature
warning light " "
3. Coolant temperature symbol "
Oil level/coolant temperature
warning light " "
This warning light has the following
three functions.
G When the engine oil level is low,
the warning light comes on and
symbol " " flashes. If this oc-
curs, stop the engine immediately
and add engine oil to the specified
level.
G
When the coolant temperature is
too high, the warning light comes
on and symbol "
the motorcycle and allow it to idle
until the coolant temperature goes
down. If the temperature does not
go down, stop the engine. (See
the "Engine overheating" section
on page 6-48 for further instruc-
tions.)
G When the engine oil level is low
"
and the coolant temperature is too
high, the warning light comes on
EAU04397
and symbols "
flash.
The electrical circuit of the warning light
can be checked according to the fol-
lowing procedure.
1. Turn the engine stop switch to
" " and the key to "ON".
2. The warning light will come on,
and symbols "
appear in the display.
If the warning light does not come on
for a few seconds, then go off, have a
Yamaha dealer check the electrical cir-
cuit.
CAUTION:
_
G
" flashes. Stop
G
_
NOTE:
_
Even if the oil is filled to the specified
level, the warning light may flicker
when riding on a slope or during sud-
den acceleration or deceleration, but
this is normal.
" and " "
_
" and " " will
3-3
Do not operate the motorcycle
until you know that the engine
oil level is sufficient.
Do not operate the engine if it is
overheated.
EC000118