Table of Contents
Advertisement
Installation
Instructions
A_
RECIRCULATING
(Non-Vented
Ductless)
INSTALLATION
OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Mount the Microwave Oven
AI.__. A TTACH THE MOUNTING
PLATE
TO THE WALL
Attach the plate to the watt using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud,
1.
Remove the toggle wings from the bolts,
2. Insert the bolts into the mounting plate through
the holes designated
to go into drywall and
reattach the toggle wings to ¾ " onto each bolt,
To use toggle
bolts:
Spacing for Toggles More
Than Wall Thickness
i
4--i*--
T oggle Wings
Plateml_
Wall
Bolt End
3.
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate,
NOTE: Before tightening toggle bolts and wood
screw, make sure to coincide bottom line of the
Mounting plate with Horizontal line of "Rear wall
Template" and then the Mounting plate is properly
centered under the cabinet.
CAUTION:
Be careful to avoid pinching fingers
between the back of the mounting plate and the wall,
4. Tighten all bolts. Pull the plate away from the wall
to help ti£hten the bolts,
A2.m.. USE TOP CABINET
TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
•
Read the instructions
on the TOP CABINET
TEMPLATE.
•
Tape it underneath
the top cabinet.
•
Drill the holes, following the instructions
on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
12
:
?7
:
::
:2
_[
;
: : ,
:"
:_
Advertisement
Table of Contents
