Related Manuals for Zektor SoloCAT HD
Summary of Contents for Zektor SoloCAT HD
-
Page 1: User Manual
User Manual SoloCAT™ HD HDMI over HDBaseT Extender with bi directional IR & RS232.atlona .com | 1-877-536-... - Page 2 Table of Contents 1. Included items pg2 2. Safety notices pg 3 3. About the SoloCAT HD™ pg 3 4. Specifications pg 4 5. SoloCAT HD™ panel connections pg 5 6. Installations pg 6 7. LED indicators pg 7 8. IR information pg 8 9.
- Page 3 Always unplug the power to the device before cleaning About the SoloCAT HD™ The SoloCAT HD ™HDMI over CAT5e/6 Extender kit is designed to be HDMI 1.4a compatible and 3D capable, enabling the reliable transmission of the HDMI; bi directional IR and bi directional RS232 signals up to 330ft in 1080p HD (even 2k/4k resolutions and 3D format).
- Page 4 Since the SoloCAT HD™ has bi-directional IR, it is the perfect device for multi-room applications and third party control systems. With bi-directional communication from a remote...
- Page 5 HD & Master Audio Power Consumption (max.) 15 Watts Operation Temperature 0°C to 70°C. Power Supply 5V 2A (universal) Zektor Gripper™ HDMI cable support brackets Dimension (in) 6 x 5 x 1 Weight (lb) 2.3 Supports Refresh Rates: 24Hz, 30Hz, 60Hz...
- Page 6 2. SoloCAT HD™v2 transmitter front SoloCAT HD™v2 transmitter rear SoloCAT HD™v2 receiver front SoloCAT HD™v2 receiver rear...
- Page 7 5. Connect the power cord and turn on the extender. 6. Turn on the source(s) and display(s) Note: when the SoloCAT HD™ is in BYPASS mode the LINK port should be left unused. 7. Use CAT5e/6 cables to link the transmitter and the receiver.
- Page 8 IR Receiver Cable, so that you can point to it easily with your IR remote controller. IR Blaster Cable Directions: Plug IR blaster cable plug into the SoloCAT HD™ “IR OUT” port, It sits in front of the source receiver’s IR sensor, which is normally located on the front-panel.
- Page 9 5. LED Indicators On the front of the SoloCAT HD™ chassis there is a horizontal block of four (4) green LED’s that is marked “Status” on the chassis just above the LED’s. From Left to Right this is an explanation of their activity: #1 LED indicates normal operations and will flash once a second with HDCP pass through.
- Page 10 Make sure you have activity lights on the SoloCAT HD™ transmitter and receiver. If no lights, remove all connections including power. Reconnect serial and/or IR if used, and power.
- Page 11 Problem: No power Action: Check for power at electrical source. Remove and reconnect to one side of the SoloCAT HD. Only use DC wall power supplies provided by Zektor. If problem persists, call Zektor tech support and request a replacement power supply.
- Page 12 Product must not be physically damaged or chassis opened. All original parts must be returned to Zektor unless instructed otherwise. Any product that shows signs of abuse or extreme wear will not be warranted. All products must be returned in reasonable condition.
- Page 13 BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, OR ANY OTHER PECUNIARY LOSS) ARISING OUT OF THE USE OF OR INABILITY TO USE THIS PRODUCT, EVEN IF ZEKTOR INCORPORATED HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. ZEKTOR INCORPORATED AND ITS SUPPLIERS’ ENTIRE...