Dacor ETT304-1 Installation Instructions Manual page 7

Cabinet Cutout Dimensions
All tolerances: +1/16 (+1.6 mm), 4, unless otherwise stated.
Before making the countertop cutout, make certain that
the required dimensions shown below have been met or
exceeded.
A - Overhead Clearances: All Installations
Cabinets that are:
Directly above cooking
surface 1
To left or right of cooking surface t, 2
Cooking surface is 3/16" (4.8 mm) thick.
2 Not applicable for cabinets more than 6" (15.2 cm) to
left or right of cooking surface.
A
30" (76.2 cm)
18" (45.7 cm)
B - Cutout Width:
Installations without Raised Vent
B =Cooktop
Models
Cutout Width
ETT304=I, MET304 28 3/4" (73.0 cm)
ETT365=2, METB365=1 34 3/4" (88.3 cm)
[
19 3/4"
2 1/4" rain. (50.2 cm)
(5.7cm) \
(2.5 cm)
B Z
J
__ISO view without
..... ralsed vent
. "_"-- 6" (15.2 cm)
min. to combustible,
side wall, both sides
Countertop Cutout Without Raised Vent Installed
D
E
m
19 3/4"
(50.2 cm)
6" min. _-
(15.2 cm)
4
..... i
C _
Cabinet
face
a
Top view with raised vent
F
1" min.
(2.5cm)
_,-- 6" min.
(15.2 cm)
f
Rear
wall A
_
3"(15.2cm) rain._
frommountingsurface to
combustibles below
_... cooktopchassis
ISO view with
raised vent
Countertop Cutout With Raised Vent Installed
Dimension Table - Installations with Raised Vent
Model/Configuration
ETT304-1 or MET304 cooktop
with ERV30 or PRV30 raised vent.
ETT304-1 or MET304 cooktop with
RV30 raised vent.
ETT365-2 or METB365-1 cooktop
with ERV36 or PRV36 raised vent.
ETT365-2 or METB365-1 cooktop
with RV36 raised vent.
B =Cooktop
Cutout Width
28 3/4"
(73.0 cm)
34 3/4"
(88.3 cm)
C - Raised
Vent Cutout
Width
27 3/4"
(70.5 cm)
33 3/4"
(85.7 cm)
D - Total
Cutout Depth
22 1/2"
(57.2 cm)
22 1/4"
(56.5 cm)
22 1/2"
(57.2 cm)
22 1/4"
(56.5 cm)
E - Raised
Vent
Cutout Depth
2 3/4"
(7.0 cm)
2 1/2"
(6.4 cm)
2 3/4"
(7.0 cm)
2 1/2"
(6.4 cm)
F - Min. Rear
Countertop
Overhang
3/8"
(1.0 cm)
5/8"
(1.6 cm)
3/8"
(1.0 cm)
5/8"
(1.6 cm)
_a_D_ 5