Proper air circulation
To assure your cabinet works at the maximum efficiency it was
designed for, you should install it in a location where there is
proper air circulation, plumbing and electrical connections.
The following are recommended clearances around the cabinet:
Sides: 2" (50mm)
Top: 2" (50mm)
Back: 2" (50mm)
Do not over fill your cabinet for proper internal air circulation.
Make sure there is a suitable power outlet (115V, 60Hz) with
proper grounding to power the cabinet.
Avoid using 3 plug adapters or cutting off the third grounding in
order to accommodate a 2 plug outlet. This is a dangerous prac-
tice since it provides no effective grounding for the cabinet and
may result in shock hazard.
Do not install your cabinet in any location not properly insu-
lated or heated. Your cabinet is not designed to operate in tem-
perature settings below 53.6°F.
Locate the cabinet on a hard and flat surface away from direct
sunlight or heat source, e.g. radiators, baseboard heaters, cook-
ing appliances etc. Any floor unevenness should be corrected
by leveling legs located on the front and rear bottom corners of
Your cabinet is designed for free-standing installation only, not
for built-in application.