Before Setting Oven Controls ... 8-9 Before Setting Surface Controls ... 10 Setting Surface Controls ... 11 Oven Control Functions (330/330i) ... 12 www.frigidaire.com USA 1-800-944-9044 & Care TA B L E O F C O N T E N T S Setting Oven Controls ...
If you do need service, help is only a phone call away. A list of toll-free customer service numbers are included in the back of this manual. Or call Frigidaire Customer Services at 1-800-944-9044, 24 hours a day, 7 days a week.
Ask your dealer to recommend a qualified technician and an authorized repair service. Know how to disconnect the power to the range at the circuit breaker or fuse box in case of an emergency. Save these instructions for future reference.
For electric ignition models only: Do not attempt to operate the range during a power failure. If the power fails, always turn off the range. If the range is not turned off and the power resumes, the range will begin to operate again.
• Use care when opening oven door , warmer drawer or lower oven door—Stand to the side of the range when opening the door of a hot oven. Let hot air or steam escape before you remove or replace food in the oven.
Conversion to Liquefied Petroleum Gas WARNING Personal injury or death from electrical shock may occur if the range is not installed by a qualified installer or electrician. Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by a qualified technician.
Your gas range features include: Electronic oven control with kitchen timer. Quick Bake Cooking System control (some models). Left front burner valve and control knob. Left rear burner valve and control knob. Center accent burner valve and control knob (some models).
BEFORE SETTING OVEN CONTROLS Oven vent location The oven vent is located below the control panel (See Fig. 1). When the oven is on, warm air passes through this vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block the oven vent.
3. Place the oven rack in positions 2, 3 or 4 only (see previous page to verify positions).Be sure the rack connector brackets are at the rear of the range and pointing towards oven bottom (See Fig. 2). 4. Assemble one connector arm at a time. With the oven...
IMPORTANT Do not place aluminum foil, or ANY material that can melt on the range cooktop. If these items melt they may damage the cooktop. NOTE The size and type of utensil used, and the amount and type of food being cooked will influence the setting needed for best cooking results.
Fig. 1 IMPORTANT • Do not place aluminum foil, or ANY material that can melt on the range cooktop. If these items melt they may permantely damage the cooktop surface. • In the event of an electrical power outage, the surface burners can be lit manually.
OVEN CONTROL FUNCTIONS READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various pad functions of the oven as described below. Set clock pad— Bake time pad— Used to set the time Used to enter the of day.
Setting the clock When the appliance is first plugged in or when the power supply to the appliance has been interrupted, the display will flash "12:00". It is recommended to always set the clock for the correct time of day before using the appliance. To set the clock: 1.
SETTING OVEN CONTROLS Setting oven lockout The control can be programmed to lock the oven door and lockout the oven control pads. To set the oven lockout feature (for models with Quick Bake) Press and hold for 3 seconds. “Loc” will appear in display, the “Door Locked”...
Setting bake The oven can be programmed to bake at any temperature from 170°F to 550°F (77°C to 287°C). The factory preset automatic bake temperature is 350°F (177°C). To set bake 1. Press . "— — —" appears in the display. 2.
SETTING OVEN CONTROLS To program oven for a delayed start time and to shut-off automatically (delayed Timed Bake) 1. Be sure that the clock shows the correct time of day. 2. Place the food in the oven. 3. Press . " — — — ° " appears in the display. 4.
Quick Bake (some models) Benefits of the Quick Bake feature — Foods may cook up to 25 to 30% faster, saving time and energy. — Multiple rack baking. — No special pans or bakeware needed. How Quick Bake works Quick Bake uses a fan to circulate the oven's heat uniformly and continuously around the oven.
SETTING OVEN CONTROLS Setting broil Use the broil feature to cook meats that require direct exposure to flame heat for optimum browing results. When broiling always remember to arrange the oven racks while oven is still cool. Position the oven rack as suggested in the broil settings table (See Fig.
Adjusting the oven temperature Your appliance has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you think the oven is cooking too hot or too cool for your recipe times, you can adjust the control so the oven cooks hotter or cooler than the temperature displayed.
Clean with soap and water. These areas are shown in white (See Fig. 1). CAUTION During the self-cleaning cycle, the outside of the range can become very hot to the touch. DO NOT leave small children unattended near the appliance.
The clock will then need to be reset. To reset, see “Setting the clock” in this Use & Care Guide. CAUTION Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.
CARE & CLEANING Removing and replacing the lift-off oven door CAUTION The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. To remove oven door: 1. Open oven door completely (horizontal with floor - See Fig.
Care & Cleaning section for additional cleaning instructions. • Range power cord is disconnected from outlet (electric ignition models only). Be sure power cord is securely plugged into the power outlet. • Electrical power outage (electric ignition models only). Burners can be lit manually.
• Be sure the light is secure in the socket. Also see “Changing & replacing the oven light” section. • Be sure floor is level, strong & stable enough to adequately support range. • If floor is sagging or sloping, contact a carpenter to correct the situation.
Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.