Advertisement
Important
Safety Warning
To reduce the risk of tipping
of the range, the range
must be secured to the floor by properly installed anti-tip
brackets and screws packed with the range. Those parts
are located in a plastic bag in the oven. Failure to install
the anti-tip
brackets will allow the range to tip over if
excessive weight is placed on an open door or if a child
climbs upon it. Serious injury might result from spilled
hot liquids or from the range itself.
Follow the instructions
below
to install
the anti-tip
brackets.
If range is ever moved to a different
location, the anti-tip
brackets
must also be moved and installed
with
the
range. To check for proper installation, see step 5.
Tools Required:
5/16" (8 mm) Nutdriver or Flat Head Screwdriver
Adjustable Wrench
Electric Drill
3/16" (4.8 ram) Diameter Drill Bit
3/16" (4.8 ram) Diameter Masonry Drill Bit (if installing
in concrete)
Anti-Tip
Brackets
Installation
Instructions
Brackets attach to the floor at the back of the range to
hold both rear leg levelers. When fastening to the floor,
be sure that screws do not penetrate electrical wiring or
plumbing. The screws provided will work in either wood
or concrete.
1.
Unfold paper template and place it flat on the floor
with the back and side edges positioned
exactly
where the back and sides of range will be located
when installed.
(Use the diagram
below to locate
brackets if template is not available.)
2.
Mark on the floor the location
of the 4 mounting
holes shown on the template. For easier installation,
3/16" (4.8 ram) diameter pilot holes 1/2" (1.3 cm)
deep can be drilled into the floor.
3.
Remove template
and place brackets on floor with
turned
up flanges
to the front.
Line up holes in
brackets
with
marks on floor
and attach
with 4
screws provided. Brackets must be secured to solid
floor. If attaching to concrete floor, first drill 3/16"
(4.8 mm) dia. pilot holes using a masonry drill bit.
4.
Level range if necessary, by adjusting 4 leg levelers
with wrench.
(See Figure 13 below.)
A minimum
clearance of 1/8" (3.2 mm) is required between the
bottom
of the range and the rear leg levelers to
allow room for the anti-tip brackets.
5.
Slide range into place making
sure rear legs are
trapped by ends of brackets. Range may need to be
shifted slightly to one side as it is being pushed back
to allow rear legs to align with brackets. You may
also grasp the top rear edge of the range and
carefully
attempt
to tilt it forward
to make sure
range is properly anchored.
SUDE
BACK
ANTFTIp
BRACKE_
3/4"
(1.9 cm)
Figure 12
Figure 13
Advertisement
