Es530 control, self-cleaning oven with deel well style cooktop (32 pages)
Summary of Contents for Frigidaire GLGFM98GPBD
Page 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. if the information in this manual is not followed exactly, a fire or explosion result causing property damage,...
ImportantNotesto the Installer Never leave children alone or unattended 1. Road all in the area where an appliance is in use. As children grow, instructions contained in these installation teach them the proper, safe use of all appliances. Never leave instructions before installing range.
A. Locate the Bracket Using the Template - (Bracket may Before Starting be located on either the left or right side of the appliance. Use Tools You Will Need the information below to locate the bracket if template is not For leveling legs and Anti-Tip Bracket: available).
Page 4
Level & Position Appliance- Level appliance by adjusting the (4) leveling legs with a wrench. NOTE: A minimum clearance of 1/8" is required between the bottom of the appliance and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slide appliance back into position.
Page 5
the 1/2" flare union adapter with an adjustable wrench before tightening the gas supply fitting and/or appliance conduit (Refer to Fig. 4e). Install flare union adapter to external manual shut-off valve. Attach appliance conduit to flare union on shut-off valve. Make sure service shut-off valve on pressure regulator is in the "ON"...
Page 6
6. Assembly of the Surface Burner Heads, Burner PLEASE READ CAREFULLY! Forpersonal Caps Burner Grates: safety, t hisproduct m ustbeproperly g rounded. It is very important to makes sure that all of the Su rface Burner Heads, Surface Burner Caps and Surface Burner G rates are Grounding instructions installed correctly and in the correct locations (See Fig.
Page 7
REMEMBER ALLOW SPILLS, FOOD, Test to verify if "LO or LOW" setting should be adjusted: CLEANING AGENTS OR ANY OTHER MATERIAL Push in and turn control to LITE until burner ignites. ENTER THE GAS ORiFiCE HOLDER OPENING. Always Push in and quickly turn knob to LOWEST POSITION. keep the Burner Caps and Burner Heads in place whenever If burner goes out, reset control to OFF.
10. Air Shutter-Oven Burner Range 12. Make Sure is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed.