Frigidaire GLGFM98GPBD Installation Instructions Manual page 6

30" gas range with sealed top burners / bake-n-warm double oven
Hide thumbs Also See for GLGFM98GPBD:
Table of Contents

Advertisement

PLEASE READ CAREFULLY! Forpersonal
safety, t hisproduct m ustbeproperly g rounded.
Grounding instructions
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle to minimize the possibility
of electric shock hazard from this appliance.
The customer
should have the wall receptacle and circuit checked by a
qualified electrician to make sure the receptacle is properly
grounded and polarized.
Preferred
Method
Grounding
_
Type
Wall
j
Receptacle
DO Not, Under
_'_
Any Circumstances,
I
Cut, Remove,
|
or Bypass the
J
rounding
pr0ng._/
]F__
Power Supply
Cord with
3-Prong
Grounding
Plug
Where a standard two-prong wall receptacle is encountered,
it is the personal responsibility and obligation of the customer
to have it replaced with a properly grounded three-prong wall
receptacle.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
TBETBIRD(GROUND)
PRONG FROMTHE POWER CORD.
letter
located
inside
Burner
Head
Burner
Head _
Match
the letter
stamped
on Burner
Skirt with
Burner Head
and Burner Cap
Electrode
6. Assembly
of the Surface
Burner
Heads,
Burner
Caps
and
Burner
Grates:
It is very important to makes sure that all of the Su rface Burner
Heads, Surface Burner Caps and Surface Burner G rates are
installed correctly and in the correct locations (See Fig. 1).
1,
2.
Match the letter located under center of Burner Cap with
letters located inside the Burner Heads (See Fig. 1).
Match the letter stamped on the Burner Skirt with the
Burner Head and Burner Cap. Each of the Burner Heads
MUST have a BumerCap installed to insure proper ignition
and gas flame size. Note: The Burner Electrodes must be
located properly in slot of each Burner Head (See Fig. 2).
Burner
Assembly
Grate
Borno - CN
Cap
Burner---.(_N
_
Head
Orifice
_
Holder
ust be
Burner
sizes
and locations
located properly in slot
Fig. 2
of each Burner Head
B = 9.5k
D=12k
E = 14 or 14.2k
A=5k
B = 9.5k
B = 9.5k
(some models)
B = 9.5k
E = 14 or 14.2k
F = 16 or 16.2
Fig. 1
Front of cooktop

Advertisement

Table of Contents
loading

Table of Contents