Frigidaire FGFB66ASD Installation Instructions Manual page 2

30" gas range with sealed top burners
Table of Contents

Advertisement

Available languages

Available languages

Important
Notes
to the Installer
1.
Read all instructions contained
in these installation
instructions before installing range.
2.
Remove all packing material from the oven compartments
before connecting the gas and electrical supply to the
range.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
Important
Note to the Consumer
1.
Keep these instructions
with your owner's guide for
future reference.
IMPORTANT SAFETY
INSTRUCTIONS
Installation of this range must conform with local codes or, in
the absence of local codes, with the National Fuel Gas Code
ANSI Z223.1--1atest
edition when installed in the United
States.
Stepping, leaning or sitting on the doors
or drawers of this range can result in serious injuries and
can also cause damage to the range.
Do not store items of interest to children
in the
cabinets above the range. Children could be seriously
burned climbing on the range to reach items.
To eliminate
the need to reach over the surface
burners, cabinet storage space above the burners
should be avoided.
Adjust surface burner flame size so it does not
extend beyond the edge of the cooking
utensil.
Excessive flame is hazardous.
Do not use the oven as a storage space. This creates
a potentially hazardous situation.
Never use your range for warming
or heating
the
room. Prolonged use of the range without adequate
ventilation can be dangerous.
Do not store or use gasoline
or other flammable
vapors and liquids
near this or any other appliance.
Explosions or fires could result.
Reset all controls to the "off" position
after using a
programmable
timing operation.
This range has been design certified by CSA International.
As with any appliance using gas and generating heat, there
are certain safety precautions you should follow. You will find
them in the Use & Care Manual, read it carefully.
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
This
range
must
be electrically
grounded
in
accordance
with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No .70_
latest edition when installed in the United States.
See Grounding Instructions on page 5.
Before installing
the range in an area covered with
linoleum
or any other synthetic
floor covering, make
sure the floor covering can withstand
heat at least
90°F above
room temperature
without shrinking,
warping
or discoloring.
Do not install the range over
carpeting unless you place an insulating pad or sheet of
1/4-inch thick plywood between the range and carpeting.
Make sure the wall coverings around the range can
withstand the heat generated by the range.
Do not obstruct the flow of combustion
air at the
oven vent nor around the base or beneath the lower
front panel of the range. Avoid touching the vent
openings or nearby surfaces as they may become hot
while the oven is in operation. This range requires fresh
air for proper burner combustion.
Never leave children alone or unattended
in the area where an appliance is in use. As children grow,
teach them the proper, safe use of all appliances. Never
leave the oven door open when the range is unattended.
FOR MODELS WITH SELF-CLEAN
FEATURE:
Remove broiler pan, food and other utensils before
self-cleaning the oven. Wipe up excess spillage. Follow
the precteaning instructions in the Owner's Guide.
Unlike the standard gas range, THIS COOKTOP IS
NOT REMOVABLE.
Do not attempt
to remove the
cooktop.
DO NOT MAKE
ANY
ATTEMPT
TO
OPERATE THE ELECTRIC IGNITION OVEN DU RING AN
ELECTRICAL
POWER
FAILURE.
RESET ALL OVEN
CONTROLS
TO "OFF" IN THE EVENT OF A POWER
FAILURE.
The electric ignitor will automatically
re-ignite the oven
burner when power resumes if the oven thermostat control
was left in the "ON" position.
When an electrical power failure occurs during use, the
surface burners will continue to operate.
During a power outage, the surface burners can be lit with
a match. Hold a lighted match to the burner, then slowly turn
the knob to the LITE position. Use extreme caution when
lighting burners this way.
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents