Advertisement
Available languages
Available languages
Cabinet
Construction
[Ir_l!_T_To
eliminate
the risk of burns or fire by
reaching
over heated
surface
units, cabinet
storage
space located above the range should
be avoided.
If
cabinet storage space is to be provided, the risk can be
reduced
by installing
a range
hood
that
projects
horizontally
a minimum
of 5" (12.7 cm) beyond
the
bottom of the cabinet.
o
Center
Line of
Range
0
Follow instructions
for
the type of installation
you have
Figure 9
If range will
be installed
with
a cabinet
on both
sides, mark center of cabinet opening on floor. If back
of range will not be flush with the wall
(the location
of the outlet may not allow the range to be positioned
against
the wall),
mark on the floor
where the back
edge of the range will be. Place the template
on the
floor aligning the template centerline with the centerline
marked in the cabinet opening.
Place the back edge of
the template against the rear wall or the line marked for
the rear of the range.
If range will be installed
with a cabinet on one side
only, move the range into final position,
Mark on the
floor along the side of the range that is not against the
cabinet. If back of range will not be flush with the
wall (the location of the outlet may not allow the range
to be positioned
against the wall), mark on the floor
where the back edge of the range will be. Place the
template on the floor and align side of template with the
line marked on the floor. Align the back of the template
with the rear wall or the line marked for the rear of the
range.
If range
will
not be installed
against
a cabinet,
move range into final position.
Mark on the floor along
both sides of the range. If back of range will
not be
flush with the wall (the location of the outlet may not
allow the range to be positioned against the wall), mark
on the floor where the back edge of the range will be.
Place the template
on the floor
and align sides of
template
with the lines marked on the floor. Align the
back of the template
with
the rear wall or the line
marked for the rear of the range.
Range Installation
_'_rl'_l_lWhen
unpacking the range, do not discard
the 4 shipping
bolts. These are to be replaced on the
unit for use as leveling legs and height adjustments.
NOTE:
1.
The back of the range may be installed
directly
against the rear wall of the structure.
2.
These ranges conform
to U.L requirements
for "0"
spacing from the range to adjacent
vertical
walls
above the countertop
level. However,
to reduce
possible scorching of vertical walls and to minimize
potential
fire hazards under abnormal
surface unit
use conditions
such as high heat or no pans, a
minimum of 2" (5.1 cm) spacing should be provided
on both sides of the cooktop.
Preparation
1.
Put on safety glasses and gloves. Remove oven racks
and parts package from inside the oven. Remove
shipping materials, tape and protective film from the
range.
2.
Take 4 cardboard corners from the carton. Stack one
on top of another.
Repeat with other
2 corners.
Place corners lengthwise
on the floor in back of the
range to support range.
Excessive
Weight
Hazard
Use 2 or more people
to move
and install
range.
Failure to follow
this instruction
can result in
back or other injury.
3.
Firmly grasp the range and gently lay it on its back
on the cardboard corners.
4.
Remove and save the 4 shipping bolts from the skid.
Discard skid.
5.
Install 4 shipping bolts as leveling legs.
6.
Place cardboard
in front
of the range.
Carefully
stand the range upright on cardboard.
7.
Adjust the leveling legs to a point where the range
base does not touch the floor.
6
Advertisement
