Frigidaire FRT18IS6CB1 Installation Tips

0
• Load refrigerator from side of cabinet only.
• Do not run retaining straps over handles.
• Do not over-tighten retaining straps.
• Never use refrigerator handles to move the refrigerator.
• Remove tape from doors only after unit is in place unless doors have
to be removed to gain access through a doorway. To remove doors,
see Door Removal Instructions below.
All four corners of refrigerator must rest firmly on a solid floor.
Your refrigerator is equipped with adjustable rollers to help
level your unit.
To adjust front rollers:
1. Remove Toe Grille (some models).
2. Use a screwdriver, 3/8" socket wrench, or nutdriver to
adjust front rollers.
Removing Toe Grille.
Adjusting Front Rollers.
1. Remove toe grille (some models) and top hinge cover.
2. Remove top hinge and lift freezer door off of center hinge pin. Set door aside.
3. Unscrew center hinge pin with adjustable wrench and save for reassembly. Ensure plastic washer stays on hinge pin.
4. Lift refrigerator door off of bottom hinge and set aside.
5. Remove center hinge and shim by removing inside screw and loosening two outside screws enough to allow hinge to slide out. Tighten outside
screws afterhinge has been removed.
6. Remove bottom hinge.
7. Set refrigerator in final location. Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical
connections:
Sides and Top 3/8"
Back 1"
8. Reinstall hinges and doors.
9. Ensure all empty holes have hole plugs in them. An envelope containing extra hole plugs is included in some models.
10. To reverse doors and handles, see "Door Removal and Reversal Instructions"in your Owner's Use and Care Manual.
iiii,_!i
Cabinet Hole
Plugs
P/N 240379102
(12594201)