Table of Contents
Advertisement
C, Level and position the range = Slide range to
its final position. Insert the range leveling leg in the
anti-tip bracket, Visually verify if the anti-tip bracket is
engaged, Lower the range by adjusting the 4 leveling legs
alternatively until the range is level, Check if the range
is level by placing a spirit level on the oven rack, Take 2
readings with the spirit level placed diagonally; take a
reading in one direction and then in the other direction,
Level the range if necessary by adjusting the leveling legs,
least 5" (12.60cm);
if regulator has been converted for
LP/Propane gas 10" (25,4cm)
manifold pressure,
inlet
pressure must be at least 11" (27,9cm).
Leak testing of the appliance shall be conducted
according to the instructions
in step 4H.
The gas supply line should be 1/2" or ¾" I.D.
NOTE:
The electric outlet can
be placed anywhere
the matched area.
Range
side
Figure 3
(21,6 cm)
Floor
Recommended
hole
location for through the
wall gas entry line.
Figure 4
Provide
an adequate
Gas Supply
When shipped from the factory, this unit is designed
to operate on 4" (10,16cm)
water column (1.0 kPa)
Natural gas manifold pressure. A convertible
pressure
regulator
is connected to the range manifold and
MUST be connected in series with the gas supply line.
If LP/Propane conversion kit has been used, follow
instructions
provided with the kit for converting the
pressure regulator to LP/Propane use.
Care must be taken during installation
of range not to
obstruct the flow of combustion
and ventilation
air.
For proper operation, the maximum inlet pressure to
the regulator should be no more than 14" (35,56cm)
of water column pressure (3.5 kPa). The inlet
pressure to the regulator must be at least 1" (.25
kPa) greater than the regulator
manifold pressure
setting. Examples: If regulator
is set for natural gas 4"
(10,16cm)
manifold pressure, inlet pressure must be at
{3.8 ¢m)
Recommended hole
location for through
the floor gas entry line.
Figure 5a
NOTE: The gas entry
line hole can be also
placed anywhere in
the shaded area.
Seal the openings
Seal any openings in the floor under the range after
gas supply line is installed.
5
Advertisement
Table of Contents
