GE DDC4500T5WH Installation Instructions Manual page 7

Installation Instructions
[_ELECTRICAL CONNECTION INFORMATION
WARNING
- TO REDUCE THE RISK
OF FIRE, ELECTRICAL SHOCK, AND
PERSONAL INJURY:
• DO NOT USE AN EXTENSION CORD
OR AN ADAPTER PLUG WITH THIS
APPLIANCE.
Dryer must be electrically grounded in accordance
with local codes and ordinances, or in the absence
of local codes, in accordance with the NATIONAL
ELECTRICAL C ODE,ANSI/NFPANO. 70.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with 120V, 60Hz, and
connected to an individual, properlg grounded branch
circuit, protected bg a iS- or 20-amp circuit breaker or
time delag fuse. If electrical supplg provided does not
meet the above specifications, it is recommended that
a licensed electrician install an approved outlet.
WARNING - THISDRYER IS
EQUIPPED WITH A THREE-PRONG
(GROUNDING) PLUG FOR YOUR
PROTECTION AGAINST SHOCK HAZARD
AND SHOULD BE PLUGGED DIRECTLY
INTO AN INDIVIDUAL, PROPERLY
GROUNDED THREE-PRONG RECEPTACLE.
DO NOT CUT OR REMOVE THE
GROUNDING PRONG FROM THIS PLUG.
ENSURE PROPER GROUND EXISTS BEFORE USE
EXTERNAL GROUND (IF REQUIRED)
An external ground wire, (not provided), which meets local
codes, may be added by attaching to the green ground
screw on the rear of the dryer, and to a grounded metal
cold water pipe or other established ground.
ATTACH GROUND WIRE (OBTAIN
LOCALLY)TO EACH DRYER
ADJUSTING FOR ELEVATION
• Gas clothes dryers input ratings are based on sea level
operation and need not be adjusted for operation at or
below 2000 ft. elevation.
For operation at elevations above 2000 ft., input ratings
should be reduced at a rate of 4 percent for each 1000 ft.
above sea level.
• Installation must conform to local codes and ordinances or,
in their absence, the NATIONAL FUELGASCODE,ANSIZ223.
NOTE TO INSTALLER
AFTER INSTALLATIONCHECKTHE FOLLOWING:
[] EXHAUST DUCT - Must meet specs in the EXHAUST
INFORMATION section.
[] GROUNDING - Dryer must be properly groundedto conform to
localcodes and ordinance requirements.
[] OPERATION - Turndryer on and checkfor heat.
[] Handcustomer the Owner's Manual- Giveinstructionson
operatingthe dryer - Answerany questions.
[] Givethese Installation Instructions to the customen
CARE AND CLEANING
USERMAINTENANCE INSTRUCTIONS
The Drum. The drum is rust-resistant and requires
no special care.
The Exterior. Wipe off any spills or washing compounds.
Wipe or dust with damp cloth. Try not to strike the surface
with sharp objects.
The Lint Filter. Wipe lint filter before every use. Periodically
lint filter should be removed and suction hose from vacuum
cleaner should be inserted into the opening.
Drger Exhaust. Inspect and clean the dryer exhaust
ducting at least once a year.
Do not obstruct the flow of combustion and ventilating air.
The air intake is located on rear of dryer.
Keep dryer area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
To store drger. For short period of time, disconnect power
supply and clean lint filter.
Do not install or store dryer where it will be exposed to the
weather.
CAUTION:
• Dryer control panel and finishes may be damaged by
some laundry pre-treatment soil and stain remover
products if such products are sprayed on or have direct
contact with the dryer.
Apply these pre-treatment products away from the
dryer. The fabric may then be washed and dried
normally. Damage to your dryer caused by pretreatment
products is not covered by your Warranty.
REGISTER YOUR NEW APPLIANCETO RECEIVEANY
IMPORTANT PRODUCTNOTIFICATIONS.
Please go to www.GEAppliunces.com or mail in the
Product Registration Card.
For questions on installation, coil: 800.626.2000 (US)or
800-561-3344 (Canada).
I