Page 1
This product must be installed by a licensed plumber or as tter When using ball-type gas shut-off valves, they shall be the T-handle type A flexible gas connector, when used, most not exceed 3 feet 234D1582P010 31-16677 03-12 GE Printed in Canada...
Installation Instructions Minimum Clearance Other Than Alcove or Closet Installation must Preparing the Installation Site and Unpacking the Dryer CAUTION: STEP 1 FOR PERSONAL SAFETY, STACKED UNITS MUST BE FASTENED SECURELY TO WALL WARNING Personal Injury Hazard Because of its weight and size, more than one person is re uired to lift, tilt or move the washer dryer Failure to do so may result in personal injury STEP 1...
Installation Instructions Alternate Method for Installation of Wall Hooks STEP 1 STEP 2 PREPARING FOR INSTALLATION OF GAS REQUIREMENTS NEW DRYER WARNING TIP: Install your dryer before installing your washer This will allow better access when installing dryer exhaust DISCONNECTING GAS TURN GAS DISCONNECT AND DISCARD OLD FLEXIBLE GAS CONNECTOR AND...
Page 4
Installation Instructions RECONNECTING GAS Listed connector ANSI Z21.24 / CSA 6.10 APPLY PIPE COMPOUND TO ALL MALE THREADS. FLARE ADAPTER 1/8" NPT PIPE PLUG FOR NEW METAL CHECKING GAS FLEXIBLE GAS INLET PRESSURE LINE CONNECTOR SHUT-OFF ADAPTER VALVE 3/8" NPT ELBOW PIPE SIZE ITEMS NOT SUPPLIED...
Installation Instructions EXHAUST INFORMATION EXHAUST CONNECTION WARNING - BEFORE PERFORMING WARNING - TO REDUCE THE RISK THIS EXHAUST INSTALLATION, BE SURE TO OF FIRE OR PERSONAL INJURY: DISCONNECT THE DRYER FROM ITS ELECTRICAL SUPPLY PROTECT YOUR HANDS AND ARMS FROM SHARP EDGES WHEN WORKING INSIDE THE CABINET BE SURE TO WEAR GLOVES REAR EXHAUST LOCATION NOTE: Add...
Installation Instructions EXHAUST CONNECTION CONT ALCOVE OR CLOSET INSTALLATION THIS DRYER COMES READY FOR REAR EXHAUSTING IF SPACE IS LIMITED, USE THESE INSTRUCTIONS TO EXHAUST MUST DIRECTLY FROM THE LEFT SIDE OR EXHAUST INFORMATION BOTTOM OF THE CABINET NOTE: This dryer cannot be exhausted to the right side Never use exible duct inside dryer...
Installation Instructions ADJUSTING FOR ELEVATION 8 ELECTRICAL CONNECTION INFORMATION WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, AND PERSONAL INJURY: DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE NOTE TO INSTALLER AFTER INSTALLATION CHECK THE FOLLOWING: ELECTRICAL REQUIREMENTS This appliance must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch...
Need help?
Do you have a question about the DDC4500TWH and is the answer not in the manual?
Questions and answers