Advertisement
Quick Links
INSTALLATION
INSTRUCTIONS
WARNING
• Use
BEFORE YOU BEGIN
IMPORTANT-
•
IMPORTANT-
•
• Note to Installer -
• Note to Customer - Keep these instructions with your Owner's Manual for future
Minimum Clearance Other Than Alcove or Closet Installation -
Preparing the Installation Site and Unpacking the Dryer
CAUTION:
FOR PERSONAL SAFETY, STACKED UNITS MUST
BE FASTENED SECURELY TO WALL.
Dryers installed in garages (if allowed by local codes) must be elevated 18
WARNING
Because of its weight and size, more than one person is required
to lift, tilt or move the washer/dryer. Failure to do so may result in
personal injury.
STEP 1 - Attach two chains using Phillips head screws to each end of
STEP 2 - Locate two wall studs behind desired operating location of stacked
NOTE: For wall studs not appropriately spaced, see section for Alternate
STEP 3 - Screw two wall hooks into two wall studs (same height as chain
NOTE:
Printed in Canada
RISK OF FIRE
Read these instructions completely and carefully.
must
Personal Injury Hazard
COMMERCIAL STACKED
ELECTRIC DRYERS
Clearance to combustible surfaces and for air opening
Tools and Materials You Need
4" diameter rigid metal duct, duct clamps,
STEP 2
STEP 3
234D2006P002 31-16312 03-13 GE
02
STEP 1
Advertisement
Related Manuals for GE DDC4400TWH
Summary of Contents for GE DDC4400TWH
- Page 1 STEP 2 - Locate two wall studs behind desired operating location of stacked NOTE: For wall studs not appropriately spaced, see section for Alternate STEP 3 STEP 3 - Screw two wall hooks into two wall studs (same height as chain NOTE: 234D2006P002 31-16312 03-13 GE Printed in Canada...
-
Page 2: Installation Instructions
Installation Instructions STEP 4 - STEP 5 - STEP 6 - Hook both chains from upper unit to appropriate STEP 7 - STEP 7 Alternate Method for Installation of Wall Hooks STEP 1 If wall studs are not correctly spaced or centered behind upper STEP 2 NOTE: If wall is concrete or block, drill holes and use appropriate CONNECTING DRYER USING 3-WIRE CONNECTION... - Page 3 Installation Instructions CONNECTING DRYER USING 4-WIRE CONNECTION • Screw Fuse Wire green • ground green ground screw screw here • Green Wire • Strain Screws • Attach ground wire of the power cord with the green • Wire • (white) •...
- Page 4 Installation Instructions EXHAUST INFORMATION (continued) TURNS OTHER THAN 90º EXHAUST SYSTEM CHECK LIST HOOD OR WALL CAP SEALING OF JOINTS INSULATION SEPARATION OF TURNS Duct work that runs through an unheated area or is near air conditioning should be insulated to reduce condensation and of straight duct, including distance between last turn and SIDE OR BOTTOM EXHAUST FIXING HOLE...