Placing A Signal Processor In The Effects Loop - Chubster 40, R30-112; Placing A Signal Processor In The Effects Loop - Suprema, Chubster 55 - Rivera R100-212A Owner's Manual

Placing a signal processor in the effects loop - Chubster 40, R30-112

PATCH
POWER AMP PREAMP
IN OUT
ARTS INSIDE. REFER SERVICING TO
Using shielded cords, connect the Patch section's Preamp Out to the processor's input,
and the processor's output to the Patch section's Power Amp In. Adjust the mixture of
effect/non-effect sounds at the signal processor, and set the processor's output level for
lowest distortion. If you use multiple signal processors, connect them in series
(processor 1's output to processor 2's input, etc.), and patch the Thirty Twelve's Preamp
Out to the first processor's input and the Thirty Twelve's Power Amp In to the last
processor's output. If the processor has stereo outputs, you can connect one to the
Power Amp In or Effects Loop Return of a second amp.
Placing a signal processor in the effects loop - Suprema, Chubster 55, R55-
112, and R100-212
RETURN EFFECTS LOOP
LEVEL
RETURN
Z IN
250K
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL
Using shielded cords, connect the Effects Loop Send to the processor's input, and the
processor's output to the Effects Loop Return. Adjust the mixture of effect/non-effect
sounds at the signal processor, and set the levels at the amp and processor for lowest
distortion. If you use multiple signal processors, connect them in series (processor 1's
output to processor 2's input, etc.), and patch the Hundred Duo Twelve's Send to the
first processor's input and the Hundred Duo Twelve's Return to the last processor's
output. If the processor has stereo outputs, you can connect one to the Effects Loop
Return of a second amp.
INPUT
SEND
LEVEL
SEND
Z OUT
560
R Series V1.0 p 20
OUTPUT
INPUT OUTPUT