XTS DVR72XX-V User Manual page 110

Important
The alarm output port should not be connected to high power load directly (It shall be less than 1A)
to avoid high current which may result in relay damage. Please use the co contactor to realize the
connection between the alarm output port and the load.
Please refer to the following sheet for detailed information.
Parameter
Alarm output
Activate
Refresh
7.3.3.3 Record
Record control interface is shown as in
Figure 7-45
Function
There are six output channels (Multiple choices).
Enable/disable alarm output device. After the Web activated the
alarm, you need to cancel the channel and then click the
activation button to cancel the alarm, or you need to cancel the
alarm in the pop-up dialogue box in local-end.
Search alarm output status.
F igure 7-46
X 4 7 4 H 4 7 4 H 4 7 4 H 4 1 6 H
.
X
110