Table of Contents
Advertisement
SOFTWARE INSTALLATION FOR WINDOWS 95/98
The following installation procedures are extracted from the Windows 98SE installation. The
installation for Windows 95 is almost same.
1. Boot-up your computer into Windows, making sure
the device driver for 'PCMCIA Socket' has been
installed and is available. To check this, right-click
'My Computer', click 'Properties' and then 'Device
Manager' to open the 'Device Manager' window.
Refer to the figure shown alongside to see if the
PCMCIA Controller is installed without error.
2. Ensure the PCMCIA interface cable and then the external power connections (if you are using the
external power) are made as described in Hardware Installation. Slowly insert the PC Card of
interface cable into the PCMCIA socket of computer and press firmly until the connector is seated
(Please note that the PC Card is keyed to guide for proper insertion).
3. If this is the very first time you are connecting the
drive to computer, the 'Add New Hardware
Wizard' dialog box appears as shown.
4. Click Next, then select 'Search for the best driver for your device' box, and click Next.
- 6 -
Advertisement
Table of Contents
