Advertisement
Dishwasher Installation
STEP 8: POSITION WATER LINE
AND HOUSE WIRING
• Position water supply line and house wiring on the floor of the
opening to avoid interference with base of dishwasher and
components under dishwasher.
Line
Wiring
Figure
M
STEP 9: INSTALL DRAIN HOSE,
THROUGH CABINET
• Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate hole.
STEP 10: SLIDE DISHWASHER
THREE-FOURTHS
OF THE WAY
INTO CABINET
IN PORTANT
- oo not push against front panel with
knees. Damage will occur.
• Grasp the sides of the front panel and slide dishwasher into
the opening a few inches at a time.
Figure O
Do not
usha
ainst
front door panel with
knee. Damage to the
door panel will occur.
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher extends
about 6 inches forward of adjacent cabinets.
• Make sure drain hose is not kinked under or behind the
dishwasher.
• Make certain the house wiring, drain line and water line do
not interfere with components under dishwasher.
Maximum Drain Hose
Length 10'
Insulatior
Blanket
Hose
/
House
Wiring
PowerCord
(if Used)
Figure
N
Tip: Prevent unnecessarg service call charges for no fill,
drain or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.
STEP 11: INSTALL TRIM PIECES
(some models)
Skip this step if trim is not supplied with the dishwasher.
In this step you will need the trim pieces set aside in Step 1.
• Position the trim pieces so the lips face toward the
dishwasher door.
• Select a long trim piece and press it onto the left side tub
flange. Start with the top edge and press the trim piece
completely onto the tub flange as you move towards the
bottom. Repeat for the right side tub flange trim piece.
• Install remaining trim piece on the top tub flange.
Trim Strip
Figure P
1
Advertisement
