Advertisement
Dishwasher Installation
STEP 16: CONNECT WATER SUPPLY
Connect water
supply
line to 90 ° elbow.
• Slide compression
nut, then ferrule over end of water line.
• Insert water line into 90 ° elbow.
• Slide ferrule against elbow and secure with compression
nut.
Test by opening and
closing the door.
Reroute the water
supply lines if a
rubbing noise or
interference
Occurs.
IMPORTANT
-
Check tobe surethatdoorspring
and/ordoorspring cable do notruborcontact thefill
hose or
water supply line.
..................
Compression
-- 90 ° Elbow
Su _'
Lne
_-
................
PPY
/
90 ° Elbow
Figure V
Door Spring
STEP 17: CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port.
• Cut drain hose connector on the marked line, if required,
to fit the inlet port.
Figure W
Cutting Line
,/
r,,-I
r =
lllllllllllll
,s/s;
BuJJJJ.uw
#
IMPORTANT: Do not cut corrugated
portion of hose
• If a longer drain hose is required and you did not purchase
drain hose GPF10L,add up to 42" length for a total of 120"
(10 feet) to the factory-installed hose. Use 5/8" or 7/8" inside
diameter hose and a coupler to connect
the two hose ends.
Secure the
connection
with hose
clamps.
Figure ×
Hose Clamp
Coupler
Hose Clamp
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET
FOR PROPER DRAIN OPERATION.
• Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure hose
with a screw-type clamp.
Method 1 - Air gap with waste tee or disposer
Waste Tee Installation
Disposer Installation
FigureY
Method 2 - "High drain loop" with waste tee or disposer
With this method you will need the drain hose hanger set aside
in Step 1.
Fasten drain hose to underside of countertop with the provided
hanger.
__
Drain Hose Hanger
32"
WasteTeeInstallation
Figure
Z
Disposer Installation
IMPORTANT
-
When connecting drain line t o
disposer,
checktobe surethatdrain plughas been removed.
DISHWASHER WILL NOT DRAIN IFPLUG ISLEFTIN PLACE.
4
Remove
Drain
Plug
Tip: Avoid unnecessarg service call charges for a no drain
complaint.
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose in the
dishwasher cavity from becoming kinked or crushed by the
dishwasher.
11
Advertisement
