Advertisement
Operating
the precoded function for your DVD
player.
This remote is designed
to operate
different
types of
DVD players.
You must first program
the remote
to
match the remote system
of your DVD player (refer to
pages 41-42 for pre-codes).
1.
Turn ON your DVD player.
2.
Aim the remote control
at the front of your DVD
player.
To switch
to DVD pre-coded
mode, use the
SOURCE ACCESS
buttons
(4 or 1_) on the remote
control
to position
the LED fight to the
corresponding
selection.
Hold down the ENT button
on the remote and enter
the four digit preset code that matches
your DVD
player, as shown
on pages 41-42.
Release the
ENT button.
The indicator
light will flash 3 times if
the code was accepted.
Aim the remote at the DVD player and press the
POWER button.
The remote will turn off your DVD
player when the correct
four digit preset code is
entered.
When this occurs,
the remote control
is
programmed
for your DVD player.
If the DVD
player does not turn off, try a different
four digit
preset code.
6.
The remote will now control your DVD player.
7.
You will need to set the display type of your DVD
player to 16:9 widescreen.
/ _BP£GT
DA¥/NIGttT
- PIP_ ",
;.© © ©:"
J
HITACHi
MY DVD PLAYER
CODE
IS:
PRECODED
DVD Buttons
These buttons
transmit
the chosen
preceded
DVD
codes.
(_)
EXCLUSIVE
TV Buttons
These buttons
are for operating
the TV.
37
Advertisement
