Advertisement
Operating the precoded function
for your set-top-
box/satellite
receiver.
This remote is designed
to operate
different
types of
set-top-box/satellite
systems.
You must first program
the remote to match the remote system
of your set-
top-box/satellite
systems
(refer to pages 41-42 for pre-
codes).
1.
Turn ON your set-top-box/satellite
systems.
2.
Aim the remote control
at the front of your set-top-
box/satellite
systems.
3,
To switch
to set-top-box/satellite
(STB) pre-coded
mode,
use the SOURCE ACCESS
buttons
(, or I_)
on the remote control
to position
the LED light to
the corresponding
selection.
4,
Hold down the ENT button
on the remote and enter
the four digit preset code that matches
your set-
top-box/satellite
receiver as shown on page 41-42.
Release the ENT button.
The indicator
light will
flash 3 times if the code was accepted.
Aim the remote at the set-top-box/satellite
receiver
and press the POWER button.
The remote will turn
off your set-top-box/satellite
receiver
when the
correct
four digit preset code is entered.
When this
occurs,
the remote control
is programmed
for your
set-top-box/satellite
receiver.
If the set-top-
box/satellite
receiver
does not turn off, try a
different
four digit preset code.
6.
The remote will now control
your set-top-
box/satellite
receiver.
(2)--
TV
OVD
CBL
ST]6
PVR AMP
O
O
O
®
O
O
SOURCE ACCESS
, _sPECl CDav/NiGnt7 PiP _ n
HITACHi
--0
MY Satellite
RECEIVER/
SET-TOP-BOX
CODE IS:
PRE-CODED
SET-TOP-BOX/SATELUTE
RECEIVER
buttons
These
buttons
transmit
tile chosen
pre-coded
set-
top-box/satellite
codes.
(_)
EXCLUSIVE
TV buttons
These
buttons
are for operating
the TV.
36
Advertisement
