Navigation Lights; Bilge Pump Switch - Skier's Choice Moomba Kanga Owner's Manual

Navigation Lights

The navigation light switch supplies power to the Bow Light,
the Stern Light and the Pole Light.
Operation: When under way at night install the Pole Light
and set the switch in the NAV position to activate all of the
running lights. When docked or at anchor at night set the
switch in the ANC position to illuminate only the pole light.
NOTE: If lights fail to operate, press the circuit breaker
reset button located above or beside the lights switch.
© 2002 Skier's Choice, Inc.

Bilge Pump Switch

The bilge pump switch operates in two positions. The manual
position is used to verify that the pump is operational.
The automatic pump function is engaged at all other times
so that any excess water in the bilge may automatically be
pumped out.
NOTE: If the Bilge Pump fails to operate in the manual
position, press the circuit breaker reset button labeled BILGE
on the circuit breaker panel under the dashboard. If the bilge
pump still does not operate, notify your Moomba dealer.
Optional Bertha Ballast Switch
To fill the ballast system press the fill switch. To empty, press
the empty switch. With the ballast full, the boat porpoises at
speeds above 25 mph.
DO NOT tow boat on trailer with ballast full.
29