Depth Sounder - Skier's Choice Moomba Kanga Owner's Manual

Depth Sounder

General Description
1. The depth finder will read to 199 ft., or the corresponding
number of meters or fathoms. If the reading is less than
19.9 ft., meters or fathoms, 1/10th increments will be
displayed. If the reading is more than 19.9 ft., all readings
will be in whole numbers.
2. The depth finder has an audible and LCD displayed depth
alarm with adjustable shallow and deep limits and a depth
below keel offset feature. The settings once made are
stored in memory and will remain even if the battery is
disconnected.
Operation:
1. Power On. The depth sounder will activate automatically
when the power to it is initially turned on. You do not have
to press the combination "ON/OFF MODE" keypad. The
LCD will illuminate showing the depth and will also show
the type of units selected, feet (FT), meters (M), or fathoms
(F). To turn the depth sounder off, press and hold the
"ON/OFF MODE" keypad for 4 seconds. Pressing the
"ON/OFF MODE" keypad again will reactivate the unit.
NOTE: The instrument is designed to have the internal
LED lighting remain on as long as power is supplied even
if the unit is turned "OFF" at the keypad.
2. Depth Alarm. Shallow mode: Pressing the "ON/OFF
MODE" keypad again displays the "SH" shallow depth
alarm setting. This is the shallowest water that will activate
the alarm. Press and hold the up or down arrow keypads
to adjust the reading to the desired depth.
Deep mode: Pressing the "ON/OFF MODE" keypad again
displays the "DP" deep depth alarm setting. This is the
deepest water that will activate the alarm. Press and hold
the up or down arrow keypads to adjust the reading to
the desired depth. When the shallow depth setting is read
by the depth sounder, the "SH" will flash on the LCD and
the audible alarm will sound rapidly. When the deep depth
setting is read by the depth sounder, the "DP" will flash on
the LCD and the audible alarm will sound at 2 beeps per
second.
28
NOTE: To fully deactivate an alarm, reset it to zero. Pressing
the "ON/OFF MODE" keypad temporarily deactivates the
alarm. To reactivate the alarm press the "ON/OFF MODE"
keypad until the depth reading appears.
3. Keel Offset. Pressing the "ON/OFF MODE" keypad again
displays the "KL" keel offset setting. This can be set so
that the depth sounder either shows the depth below the
keel or the depth below the transducer. Press the up or
down arrow keypads to adjust the reading to the desired
depth no more than 19.9 ft. For example if the bottom of
the keel is 2 ft below the transducer and you want the
depth sounder to read the depth below the keel, the display
should be adjusted to read 2.0 ft
NOTE: Once a keel offset is programmed, the shallow and
deep alarms will be activated by the depth below the keel.
4. Units. Pressing the "ON/OFF MODE" keypad again
displays "Un" on the LCD indicating the units mode. Press
either the up or down arrow keypads to set the units desired
to feet (FT), meters (M), or fathoms (F). These units,
once set, will remain the same for all modes. Pressing
the "ON/OFF MODE" keypad again returns the depth
sounder to normal operation.
Stereo
Remote Control Pad
Please refer to your stereo owner's manual for proper
operation instruction.
The stereo cannot be turned off by the
remote. The "SRC" button on the stereo unit must be held
down for 3 seconds to completely turn the stereo off.
Continue to hold the SRC button until display goes blank.
If the face displays "ALL OFF", your stereo
is in standby mode and drawing battery power which will
drain the battery and may lead to a dead battery.
© 2002 Skier's Choice, Inc.