Advertisement
Available languages
Available languages
ALLURE ® QSE1 SERIES
RANGE HOOD
Page 3
PREPARE THE HOOD
PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3 ¼" x 10"
Vertical Discharge)
DAM PER/DUCT
CONNECTOR
El
Remove
Connector
from inside the hood.
Damper/Duct
Set connector aside - with mounting screws and parts
bag.
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3 ¼" x 10"
Horizontal Discharge)
El
Remove appropriate Duct Knockout(s)
from top or back of
hood.
WIRING
COVER
UPTO 1"
SIDE-TO-SIDE
ADJUSTMENT
TAPE
TOP/BACK
EDGE
El
Remove Wiring Cover from inside the hood. Set cover
and mounting screw aside.
O
DAMPER/DUCT
CO NN ECTO R
(Vertical discharge
position shown)
3W' x 10" Ducted Discharge
Only: Attach Damper/Duct
Connector
over knockout opening. Make sure damper Pivot
is nearest to Top/Back
Edg#_ of hood. Remove _
from
damper flap.
Damper/Duct Connector can be installed up to 1-inch
on either side of hood center to accomodate off-center
ductwork. In extreme off-center installations, one end
of the duct connector may need to be trimmed to clear
the electrical cable clamp.
ELECTRICAL
CABLE CLAMP
Remove either
back
knockout and install
top
or
wiring
ap-
proved Electrical
Cable Clamp.
Advertisement
