Electrical Supply; Wiring Requirements - Bosch HBN742AUC-01 Installation Instructions Manual

ELECTRICAL SUPPLY
Before installing the oven have a qualified elec-
trician verify that your home is provided with ad-
equate electrical service and that the addition of the
oven will not overload the branch circuit on which
it is to be installed. A separate three-wire or four-
wire single phasQ 240 Volt, 60 Hz, or a 208 Volt, 60
Hz branch circuit is required.
NOTE: For use with 208 V, 60 Hz supply voltage,
see ( o_ectmg to = 08 _o/t Circuit.
For hook-up of the oven you will need to have an
approved junction box installed where it will be eas-
ily reached through the front of the cabinet where
the oven will be located. The oven has 3 feet of con-
duit. Allow two to three feet of slack in the line so
that the oven can be moved if servicing is ever nec-
essalw. DO NOT shorten the flexible conduit.
WARNING
ELECTRICAL SHOCK HAZARD
, The electrical power to the oven branch cir-
cuit must be shut offwhile line connections
are being made.
* Do not rise an extension cord with this ap=
pliance.
* Electrical ground is required on this appli-
ance. The flee end of the green wire (the
gronnd wire) mnst be connected to a suit-
able ground.
This wire must remain grounded to the oven.
, If cold water pipe is interrupted by plastic,
nonmetallic gaskets, nnion connections or
other insulating materials, DO NOT use for
grounding.
, DO NOT ground to a gas pipe.
, DO NOT have a fllse in the NEUTRAL or
GROIE'_DING circnit. A fllse in the NEU=
TP,AL or GROUNDING circuit conld re=
sult in an electrical shock.
* Check with a qualified electrician if yon are
in doubt as to whether the appliance is prop-
erly grounded.
Failure to follow these instructions could re-
snlt in serions inim T or death.
WIRING REQUIREMENTS
When making the wire connections, use the en-
tire length of the conduit provided (3 feet). The con=
dnit must not be cut.
Before making connections make sme the power
is offand read and obse_we the following:
1. A separate three=wire or fonr wire, single phase,
240 Volt, 60 Hz or 208 Volt, 60 Hz branch circnit
is required for the oven.
2. The oven mnst be connected with COPPER
WIRE ONLY.
3. In the United States:
Wiring must conform to the National Electrical
Code, ANSI/NFPA No. 70 latest edition.
Yon can obtain a copy of the National Electrical
Code by writing:
National Fire Protection Association
Batterymarch Park
Qnincy, MA 02269
NISE EN GARDE
DANGER DE CHOC ELECTRIQUE
, Le conmnt 41ectriqne alhnentant le %ur doit
_tre conpd dnrant le branchement.
, N'ntilisez pas de mllonge dlectriqne avec
cet appareil.
, Cet appareil ndcessite une raise 'a la terre.
L'extrdmitd dn fil vert (ill de raise i_la terre)
doit 6Ire relide i_nne raise i_la terre addqnate.
Ce fil dlectrique doit rester mlid an £onr.
, Si les tnyanx d'ean floide comportent des
parties en plastiqne, des joints non-
mdtalliqnes on d'antres matdrianx isolants,
NE LES UTILISEZ PAS pont la imse a la
terre.
, N'UTILISEZ }'AS DE TUYAUX DE GAZ
pour la 1rose i_la terre.
, Ne placez pas de filsible sur le fil NEUTRE
ou le fil de MISE A LA TERRE. Un tel ills=
ible ponrmit resnlter en nn choc dlectriqne.
, Si vons avez le moindre doute, I_ites vdfifier
par un dlectficien qne votre appareil est bien
mis i_ la terre.
Le _i_it de ne passe conformer/_ ces instruc-
tions peut entrainer de sdrienses blessnres on
la mort.