Please Read Carefully - Bosch HGS5053UC/01 Installation Instructions Manual

5. Read these electrical connection details first
then connect electricity to range.
Before servicing, disconnect electrical
supply at circuit breaker, fuse or power cord.
Electric Requirements: A dedicated, properly grounded and
polarized branch circuit protected by a 15 amp. circuit breaker
or time delay fuse. See serial plate for proper voltage.
Extension Cord Precautions:
Because of potential safety hazards under certain conditions,
we strongly recommend against the use of any extension
cord. However, if you still elect to use an extension cord, it is
absolutely necessary that it be a UL listed 3-wire grounding
type appliance extension cord and that the current carrying
rating of the cord in amperes be equivalent to orgreater than
the branch circuit rating. Such extension cords are obtainable
through your local service organization.
PLEASE READ CAREFULLY! Forpersonal
safety, this product must be properly grounded.
Preferred Method /fDo Not, Under
.,mAny Circumstances, I
_Cut, Remove, |
JF_I or Bypass the J
Grounding Prong..,/
]P"_ Power Supply
Grounding Cord with
Type 3-Prong
Wall Grounding
Receptacle Plug
Where a standard two-prong wall receptacle is encountered,
it is the personal responsibility and obligation of the customer
to have it replaced with a properly grounded three-prong wall
receptacle.
DO NOT, UNDERANYCIRCUMSTANCES, CUTOR REMOVE
THE THIRD (GROUND) PRONG FROM THE POWER CORD.
Grounding Instructions
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle to minimize the possibility
of electric shock hazard from this appliance. The customer
should have the wall receptacle and circuit checked by a
qualified electrician to make sure the receptacle is properly
grounded and polarized.
6. Assembly of the Burner Caps and Burner
Grates:
It is very important to makes sure that all of the Surface Burner
Caps and Surface Burner Grates are installed correctly and in
the correct locations.
Please Note: The burner heads are secured to the
cooktop. THE COOKTOP IS NOT REMOVABLE. Do not
attempt to remove or lift the cooktop.
REMEMBER -- DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO
ENTER THE GAS ORIFICE HOLDER OPENING. Always
keep the Burner Caps and Burner Heads in place whenever
the surface burners are in use.