Related Manuals for SurgeX XU115
Summary of Contents for SurgeX XU115
- Page 1 USER MANUAL SurgeX XU115 Line Interactive 1000VA UPS with Automatic Voltage Regulation Surge Eliminator / Power Conditioner XU115-510...
-
Page 2: Table Of Contents
XU115 Manual INTRODUCTION ............................2 INSTALLATION ............................2 ..........................2 VOLT CONNECTIONS ..........................2 ATTERY CONNECTION ........................2 CONNECTING YOUR EQUIPMENT ....................3 USB COMMUNICATIONS PORT CONNECTION ................3 PHONE MODEM NETWORK PROTECTION CONNECTION OPERATION .............................. 3 ..........................3 CHARGING THE BATTERY ........................... -
Page 3: Introduction
INSTALLATION The SurgeX XU115 is designed to be installed in a 19 inch equipment rack and requires two units (2-U) of rack space. Remove the product from its packaging and slide it into place in the rack being careful to feed the power cord into the rack first and guide it so that it does not get caught or jammed as the product is installed. -
Page 4: Usb Communications Port Connection
XU115 Manual USB Communications Port Connection (optional) The Power Monitoring Software can be used with the UPS. Use the interface cable that comes with the UPS. Connect one end of the USB cable to the USB communications port on the rear panel of the UPS. Connect the other end of the USB cable to the device that will be monitoring/controlling the UPS. -
Page 5: Led Indicators
XU115 Manual LED INDICATORS There are four LED indicators located on the front panel. Their function is as follows: Surge SELF TEST (Green): When illuminated, the surge suppression circuitry is functioning correctly. Status LED and Alarm Table UPS Status Green LED... -
Page 6: Troubleshooting
XU115 Manual UPS Fault – When the UPS detects a hardware fault, the Bad Battery/Overload/Fault LED will illuminate and the UPS will sound a constant alarm. The fault condition, in some instances, may be reset by turning the UPS off and then on. -
Page 7: Replacing The Battery
XU115 Manual REPLACING THE BATTERY (Qualified Service Personnel Only) Please read all warnings and cautions before attempting to service the batteries. WARNING! This UPS contains potentially hazardous voltages. Do not attempt to disassemble the UPS beyond the battery replacement procedure. This UPS contains no user serviceable parts. Repairs and battery replacement must be performed by Qualified Service Personnel Only. - Page 8 XU115 Manual SPECIFICATIONS AC Input Number of Phases: Single (2W + G) Power Cord: 6-ft. grounded, 3 wire, #14 line cord Input Voltage (Acceptable Input Voltage): 120VAC (0 - 160VAC) Input Voltage Range (Normal mode): 90 - 150VAC DC Start Capability: Yes, (defaults to 60Hz)
-
Page 9: Specifications
XU115 Manual Surge Protection Specifications Surge Protection: Advanced Series Mode® surge elimination Surge Energy Rating: 6,000 volts/3,000 amps Let through Voltage (6,000 volt surge): 0 volts UL 1449 Adjunct Classification Test Results: 1000 surges, 6000 volts, 3000 amps, B3 pulse; Measured suppressed voltage: 170 volts;...
Need help?
Do you have a question about the XU115 and is the answer not in the manual?
Questions and answers