Starting The Appliance - Haier HDW9SS Owner's Manual

Haier domestic dishwasher owner manual

Hide thumbs Also See for HDW9SS:

Table of Contents

Starting the Appliance

Starting a wash cycle

- Make sure that the plug for the appliance is inserted into the wall

socket.

- Make sure that the water supply is turned on to full pressure.

- Load the dishwasher (see the section entitled, "Loading the

Dishwasher").

- Pour in the detergent (see the section entitled, "Detergent

and Rinse Aid").

- Turn the knob located on the right of the control panel in the

clockwise direction until the number or symbol for the cycle sec-

tion entitled, "Wash Cycle Table").

- Press the ON-OFF button, and the ON-OFF light will turn on. At

this point, the wash cycle will begin.

Important:

In general, it is not advisable to open the door while the machine

is working. Care must be taken if the door is opened during the

hot phase or immediately after a programm has finished as steam

may escape.

Cancelling or modifying a wash cycle setting

Press the ON-OFF button and the ON Light will turn off. Rotate

the knob in the clockwise direction to the desired cycle setting

(see the section entitled, "Starting a wash cycle..."). Then, turn

the dishwasher back on using the ON-OFF button.

At the end of the wash cycle

When the knob stops turning and is aligned with a STOP mark

(see figure), the cycle has finished. Turn off the appliance using

the ON-OFF button, turn off the water supply and open the door

of the dishwasher.

Wait a few minutes before unloading the dishwasher to avoid

handling the dishes and utensils while they are still hot and more

susceptible to breakage. They will also dry better.

.5.

Table of Contents

Hdw9wh