Back Panel Controls And Connectors - XTE Electronic Digital Technology XTDT3200 User Manual

Back panel controls and connectors

12. Fan discharge grids
The fan of the cooling system creates an airflow
with for/back direction. The air for cooling the
amplifier is taken from the opening on the front
side and it is then discharged through the opening
on the back.
Attention:
openings.
13. A.C. Mains cable
Make sure that the cable is undamaged and that
the connecting plug has ground /earth connection.
14. S.N. tag
Every unit has a tag that shows: model, power
consumption and serial number.
15. Speakon output connectors
There is a connector for every channel when
operating in stereo or parallel mode. For operating
in bridge use connector A (C) (refer to drw. page
9, 10, 11)
Fig.3a Back panel XTDT3200 XTDT3800
Fig.3b Back panel XTDT4800F XTDT6000F
do not obstruct these
16. Switch for mode setting
Switch to set the usage mode (refer to drawings
page 9, 10 and 11)
17. Input connectors
Combo connectors (female XLR with 6.3mm jack)
and Europlug, a connector for every channel for
balanced or unbalanced inputs. Attention: noises
such as buzzing or
loudspeakers
installing wiring next to dimmer, motors,
etc. Balanced
considerably such noises.
18. HPF filter Switch ON/OFF
This switch enables the filter circuit.
19. Data port
This port is used as Input/Output connection with
the optional expansion cards such as DSP or
customised modules to equalize or to filter the
signal. For further information refer to the DSP
User's Guide.
disturbance on the
may occur when
connections reduce