Declaration Of Conformity; User's Liability - XTE Electronic Digital Technology XTDT3200 User Manual

Declaration of conformity

This device conforms to the requirements of
the EMC directive 89/336/EEC, amended by
92/31/EEC, and the requirements of the Low
Voltage Directive 73/23/EEC, amended by
93/68/EEC.
Standards Applied:
EN55103-1 (Emissions)
EN55103-2 (Immunity)
EN60065, Class I (Safety)

User's liability

Damages to the loudspeakers
Always check the peak and continuous power of
the loudspeakers.
This amplifier is extremely powerful and can be
potentially dangerous both for the loudspeakers
and for the persons.
Most loudspeakers may be easily damaged or
broken, especially by amplifiers operating in
bridge. Even if there is a gain reduction through
the attenuators on the amplifier's front panel, it is
still possible to reach the maximum output power
if the input signal level is high enough.
Dangerous output voltage
The amplifier can generate hazardous output
voltage. Do not touch exposed cables
loudspeakers with the amplifier in operation.
Radio interferences
A sample of this product has been tested and
approved to meet the requirements of the
Electromagnetic Compatibility Directive (EMC).
These requirements have been defined so as to
provide reasonable protection against dangerous
interference of electrical equipment. Whenever
this product has not been installed or handled
according to these guidelines, it might interfere
with other equipment such as radio receivers.
However, there is no guarantee that they should
not occur in a specific installation. Should this
equipment interfere with transceiver equipment
(such possibility can be checked by switching on
and off the device), the user should try to cancel
the interference by observing one or more of the
following measures:
- Increase the distance between the device and
the receiver.
- Connect the device to a plug linked to a
different circuit with respect to the one to
which the receiver is connected.
- Redirect or move the receiver's antenna.
- Make sure that the unit concerned conforms
to the EMC immunity limits (CE-labelled). All
electrical equipment sold in the EC should be
approved as for what concerns protection
against electromagnetic fields, high tension
and radio interference.
- Contact qualified personnel.
of