Protection Features - XTE Electronic Digital Technology XTDT3200 User Manual

Protection features

All professional XTE amplifiers are equipped with
strong protection systems
amplifier and its load. These protection systems
ensure the power amplifier a long operating life.
Limiter
When the limiter is ON the CLIP/LIM LED lights
on. With the limiter intervention the channel gain
will automatically lower to protect the load
(loudspeaker) from damage caused by signal
distortion. It is not possible to disable the limiter's
circuit.
Thermal protection
The temperature state of the dissipator is
constantly checked, the HI-Temp LED gives
indications on the temperature status. The Hi-
Temp starts flashing if the dissipater reaches a
temperature of 60º C. In such case the input
signal of the relevant channel will be automatically
decreased until a temperature for the correct
running is reached. If the Hi-Temp LED stops
flashing and the light remains on (anomalous
working condition) the whole system will go to
mute until the temperature reaches normal levels.
Power security check
On XTE amplifiers the output current is constantly
checked as well as the input signal condition. If
the current exceeds the maximum allowed level,
output tension will be automatically readjusted in
order to assure the amplifiers' security status.
Power security control acts especially in case of
connection to a load with impedance lower than
the recommended levels or if at the amplifier's
output a non acoustic signal is released during
long periods of time.
that shelter the
DC protection
If a value higher than or equal to 7V occurs, the
presence of a DC on channels will be monitored,
and the amplifier's output stage and the switching
supply will be blocked. This allows loudspeaker
protection from the DC.
Absorption limitation
The power XTE amplifiers are provided with a
soft-start system to reduce the absorption when
switched on. This feature is particularly useful in
multiple amplifiers installations.
Power supply protection
The A.C. voltage is monitored; if its value does not
fall within the correct running range (over or under
voltage) the supply will be automatically blocked.
The amplifier will restart when the main supply
voltage exceeds the minimum running tension or
is under the maximum running voltage.
Switch-on/turn-off transients
A mute circuit (without relay), with a delayed
starting up and immediate power turning off, has
been inserted in order to avoid the switch-on/turn-
off transients that may cause damage to the
loudspeakers
Maintenance information
Please contact the
Professional Assistance
Dealer, or XTE Audio
assistance.
nearest XTE Audio
Service, Distributor,
(Italy), for maintenance