Electrical Requirements - Jenn-Air JB36SEFXRB Installation Instructions Manual

Agrounded 3 prong electrical outlet s hould beplaced w ithin
4"(10.2 cm) o ftheright s ide cabinets orendpanel. See
"Electrical Requirements" foradditional information.
The water s hutoff should belocated i nthebase cabinet on
either s ide oftherefrigerator orsome other e asily a ccessible
area. I fthewater shutoff valve isnotinthecabinets, the
plumbing forthewater l inecancome through t hefloor o rthe
back wall. S ee "Water Supply R equirements" formore
specific i nformation.
0
0
ii 80"-g0" ii
==i i(203"229 cm)i i=
831/2" (212.1 cm) min.
843/4" (215 cm) max.
to bottom of solid soffit
/
Dimension
77"
(196 cm)
A
Width
(see chart following)
t
(15.2 c
24"
(60.96 cm) min.
Width A Width A for Dimension B
(as shown Overlay Models (as shown
Model above) (as shown above) above)
36 351/2" to 353/4 '' 353/4" to 36" 4" (10.2 cm)
(90.2 cm to (90.8 cm to 91.4 cm)
90.8 cm)
42 411/2" to 413/4 '' 413/4" to 42" 10" (25.4 cm)
(105.4 cm to (106 cm to 106.7 cm)
106 cm)
NOTE: Flooring under refrigerator must be at same level as the
room.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
IMPORTANT: If this product is connected to a GFCI (Ground
Fault Circuit Interrupter) protected outlet, nuisance tripping of the
power supply may occur, resulting in loss of cooling. Food quality
and flavor may be affected. If nuisance tripping has occurred,
and if the condition of the food appears poor, dispose of it.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, remove the top grille and turn the master
power switch to OFF or disconnect power at the circuit breaker
box.
When you are finished, turn ON the master power switch or
reconnect power at the circuit breaker box. Then reset the control
to the desired setting.