Fenton S1000A User Manual page 14

Installation & Operation Instructions
7. Perform the Power Failure Test
Pull out the AC power cord from the wall receptacle to test
the operation of UPS on battery backup function. Make sure
that your computer and other devices are running normally.
8. Turn Off the UPS
Before you turn off the UPS power, please make sure that
your computer and other devices are properly shut down.
Push the Power Switch to turn off the UPS.
9. To ensure your computer equipment to be protected during
an AC utility power failure, it is important to make sure that
the maximum power needed by the equipment is not over the
rated capacity of the UPS. If your equipment is overloading
the UPS, then the red LED will light up (LED version), or the
"Over load" symbol will show up (LCD version), and the alarm
will beep. Furthermore, if the overload is severe, the UPS will
shut down immediately for protecting UPS itself.
10. After installed under the AC mode, the UPS will charge the
battery automatically, and the status LED (in LED version)
blinks green every 2 seconds; or in LCD version, the battery
symbol and battery level will blink every second during
charging. If AC auto turn-on function is enabled, the UPS
will turn on automatically when utility power is green. If auto
turn on is disabled, please push the button for one second
on the front panel, then the UPS will supply power to the
outlets after a short-time of self-test.
12