Table of Contents
Advertisement
Quick Links
INSTALLATION
AND SERVICE MUST BE PERFORMED
BY A QUALIFIED
INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL
INSPECTOR'S
USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
If the information in this manual is not followed I
exactly,
a fire or explosion
may result causing
property
damage, personal injury or death.
FOR YOUR SAFETY:
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
--
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone
in your building.
• Immediately
call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire
department.
--
Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
)
A
w
--
v
V
• ALL RANGES
CAN TIP
• |NJURYTO
PERSONS
COULD RESULT
• INSTALL ANTI-TIP
DEVICE PACKED WITH
RANGE
• SEE INSTALLATION
INSTRUCTIONS
RANGE
OVERALL
253/4"
DIMENSIONS
<--
30-1/8" -_......_._
47-3/4"
_
!
Maximum
36_+i/8.
Door Open
29 7/8"""_
2>
SIDE
VIEW
* Note: 3"
Clearance
Minimum
Minimum
to
if Equipped
. Cabinets
on
Maximum
Depth
with 11000
or
I
Either Side
for Cabinets
greater BTU Burners.
of Range.
Above Range Top.
0" Clearance Below Cooking Top and at Rear of Range.
Clearances
and Dimensions
1.
2.
Provide Proper Fuel Type
Location--Checklocationwhere
Before Proceeding: Your range is preset to operate on natural gas only. This
the rn_Dg__willbein
t I_.Check
model was shipped convertible from the factory with the necessary parts and
for proper electrical
and gas
conversion instructionssupplied.
supply, and the stability of the
floor.
Dimensions that are shown must
IIr_
DO NOT attempttoconvertthisrange toLP/Propane settingswithout
be used.
Given
dimensions
theproperLP/Propaneconversionkitprovidedwiththerangeorobtainedfmmyour
provide
minimum
clearance,
dealer. Follow all instructionsprovided with this conversion kit.
Contact surface must be solid
and level.
EspaSol - Paginas 9-16
P/N 316259313 (0112)
1
Advertisement
Table of Contents
Related Manuals for Kenmore 79075663200
Summary of Contents for Kenmore 79075663200
- Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed I exactly, a fire or explosion may result causing property damage, personal injury or death.
-
Page 2: For Models With Self-Clean Feature
Important Notes to the Installer Never leave children alone or unattended Read all instructions contained in these installation in the area where an appliance is in use. Aschildrengrow, instructionsbefore installingrange. teachthem the proper, safe useofall appliances. Never leave Remove all packingmaterial from theoven compartments the oven door open when the range is unattended. -
Page 3: Before Starting
Locate the Bracket Using the Template - (Bracket may Before Starting be locatedon eitherthe left or rightside ofthe range. Use Tools You Will Need the intormation below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available), Mark the floor or wall where left or right side of the range will be located. - Page 4 C. Level and Position Range- Level rangebyadjusting the (4) levelinglegswithawrench. Note:A minimum clearance of 1/8"isrequiredbetween the bottomoftherangeand the leveling legto allowroomfor the bracket. Usea spiritlevel tocheckyouradjustments. Sliderangebackintoposition. Visually check that rear leveling leg is inserted intoand fully secured by the Anti-Tip Bracket by removing lower panel or storagedrawer.
- Page 5 5. Read electrical connection details below Manual Flare Flexible Flare Union Pressure and connect electricity to range. Shutoff Union Appliance Adaptor Regulator Valve Conduit € Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Reauirements: An individual,properly grounded and polarizedbranchcircuitpretected bya 15 amp.
- Page 6 Electric Ignition Surface Burners Operation of Surface Burners Operation of e_ectric ignitersshould be checked after range 6. Installation of Surface Burner Caps and supply line connectors have been carefully checked for Your range is equipped with any combinationof the sealed leaks and range has been connected to electric power.
-
Page 7: Oven Adjustments
8. Adjust the "LOW" Setting of Surface Burner seconds after the thermostat is turned ON before the flame appears at the oven burner. When the oven reaches the dial Valve (Linear Flow Valves Only): setting, the glowing igniter will go off. The burnerflame will go "out"... -
Page 8: Care, Cleaning And Maintenance
Care, Cleaning and Maintenance Burner Refer to the Use & Care Guide for cleaning instructions. If removing the range is necessary for cleaning maintenance, shut off gas supply. Disconnect the gas and electrical supply. Ifthe gas or electrical supply is inaccessible, Lock Screw ®...