Table of Contents
Advertisement
Operation of Surface Burners
6, Installation of Surface Burner Caps
Your range is equipped with any combinationof the sealed
burners. Refer to the illustration below to find your surface
burner and surface burnercap configuration. Be sureto place
the correct burner cap at on all four surface burners.
_9.5k
Possible Surface Burner and Cap configurations
Install the parts illustrated below at all four surface burner
locations:
1st - Install the surface burner pans (if equipped);
2nd -install the surface burner heads;
3rd - install the surface burner caps and
4th;install the burner grates.
Surface
Burner
e
Surface
Cap
7.
Electric
Ignition
Surface
Burners
Operation of electric ignitersshouldbe checked after range
and supply line connectorshave been carefullychecked for
leaks and range has been connected to electric power.
a.
To check for proper lighting, push in and turn a surface
burner knob counterclockwise to the LITE position. You
will hear the igniter sparking (see illustration below).
b,
The surface burner should light when gas is available to
thetopburner. Purge air from supply lines byleaving knob
in the LITE position until burner ignites.
Each burner
should light within four (4) seconds in normal operation
after air has been purged from supply lines.
c.
Visually check that burner has lit. Once the burner lights,
the control knob should be turned out of the LITE position.
d.
There are separate electrodes (igniters) for each burner.
Try each knob separately until all bumervalves have been
checked.
Note: Knob styles and colors may vary from that pictured.
\
Surface
Burner
_
Head
Removable
Burner
Drip Pan
(on some
models)
6
Advertisement
Table of Contents
